Telcoma EDGE2 radio gate opener, 2 channels, 433.92 MHz, rolling code

1st method:
A fully functioning radio control is required for duplication.
1 - Press and hold down button 2 (top right) of the new remote control and simultaneously press button 1 (top left) 4 times.
2 - Release button 1 (top left); the LED on the new remote control will flash slowly.
3 - Press and hold down the button you wish to duplicate the working remote control; the LED on the new remote control will light up steadily.
4 - Release button 2 (top right); the LED on the new radio control will start flashing quickly.
5 - Now press the button of the new remote control to which you wish to assign the new code and release it only when the LED lights up steadily.
6 - Approach the receiver and press the button of the newly coded remote control until the automation is activated.

2nd method:
The memorisation procedure must be carried out by acting directly on the receiver.
1 - Press and release the P1 button on the receiver; LED L1 will emit a series of 5 flashes.
2 - During the flashing of the LED on the receiver, press the button of the new remote control to be programmed.
3 - LED L1 will light up for approximately 3 seconds to confirm correct memorisation.
4 - The led L1 will start flashing again waiting for a new remote control to be memorised, if within 5 flashes no new one is received, the receiver will automatically exit the learning phase.
6 - Follow the same procedure for the second key (press button P2 on the receiver).