Benincà TO-GO4VA radio gate opener, 4 channels, 433.92 MHz, rolling code

The remote control is supplied with ARC (128-bit) coding at the factory. To change the encoding type, press keys 1 and 2 simultaneously for 20 seconds.
After a few seconds, the LED starts flashing to indicate the mode that is about to be activated:
- 2 flashes and pause 1 second: the remote control is about to be configured as HCS (64 bit)
- 3 flashes and pause 1 second: the remote control is about to be configured as ARC (128 bit)
When the LED lights up steady, release the keys; the radio control has changed mode.

A fully functioning radio control is required for duplication. and the duplication procedure must be carried out in the vicinity of the receiver.
Programming:
- One WB /WI receivers
1 - Activate the hidden button of the functioning radio control by simultaneously pressing keys T1 and T2 for 3 seconds (in earlier models the hidden button is located inside the radio control); the red LED starts flashing.
2 - Within 5 seconds, press the open button on the working remote control.
3 - Press the equivalent key on the new remote control within 5 seconds.
4 - Wait 10 seconds and test the correct operation of the new remote control.

- Receivers incorporated in control units
1 - Activate the hidden button of the functioning remote control by simultaneously pressing keys T1 and T2 for 3 seconds (in earlier models, the hidden button is located inside the remote control); the red LED begins to flash.
2 - Press the open button of the working radio control within 5 seconds.
3 - Activate the hidden button of the new remote control by simultaneously pressing keys T1 and T2 for 3 seconds; the red LED begins to flash.
4 - Press the equivalent key of the new remote control within 5 seconds.
5 - Wait 10 seconds and test the correct operation of the new remote control.